Olivetti OFX 2100 Instruction Manual page 6

FOR USA USERS
FCC Regulation
In accordance with FCC regulations, the following information concerns the information required
to be supplied on a fax.
Part 68, Section 68.381 (c) (3) of FCC Regulations states the following:
"Telephone facsimile machines: identification of the sender of the message. It shall be unlawful for
any person within the United States to use a computer or other electronic device to send any
message via a telephone facsimile machine unless such message clearly contains, in a margin at
the top or bottom of each transmitted page or on the first page of the transmission, the date and
time it is sent and an identification of the business, other entity, or individual sending the message
and the telephone number of the sending machine or such business, other entity, or individual.
Telephone facsimile machines manufactured on and after December 20, 1992 must clearly mark
such identifying information on each transmitted message".
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to Part 15 of the FCC Rules.
These limits are designated to provide reasonable protection against interference in a residential
installation.
This equipment generates, used and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet of a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for assistance.
Changes or modification not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Connecting of peripherals required the use of grounded shielded signals cables.
This equipment complies with Part 68 of the FCC rules. On the rear of this equipment is a label that
contains, among other information, the FCC Registration Number and Ringer Equivalence Number
(REN) for this equipment. You must, upon request, provide this information to your telephone
company.
This equipment uses the following USOC jacks: RJIIC
warb2100.p65 1 13/04/00, 23.17