Olivetti OFX 2100 Instruction Manual page 35

9. Press SET/CONF . to confirm the number set.
At this point, as the remaining parameters are optio-
nal, you can quit the menu by pressing STOP twice.
The facsimile returns to stand-by mode.
10. Enter the relevant telephone number - max. 30 digits
- on the numeric keypad - e.g. LANDRE S.p.A..
Each character is entered by pressing the ∨ ∨ or ∧ ∧ key
to scroll through the entire set of alphanumeric
characters until the desired character is displayed and
then by pressing the > key to confirm selection. The
character to be selected appears in the top right-hand
corner. (For a complete list of the alphanumeric
characters available, refer to the "CHARACTER SET
TABLE" chapter).
To delete an entire setting, press CLEAR and repeat
the entire entry procedure.
11. Press SET/CONF. to confirm the name stored.
Type the relevant telephone number - max. 32 digits -
on the numeric keypad, e.g. 0125 230025. Remember
that extended coded dialling codes 31 and 32 may
consist of 100 digits.
If the display shows a previously set number, you can
confirm it by pressing SET/CONF. , or replace it with a
new number by typing the new number on the numeric
keypad and pressing SET/CONF. .
To delete a setting, press CLEAR .
To correct a typing mistake, move the cursor to the
digit to be changed (using the < or > key) and
overwrite it with the new digit.
You can also insert pauses, leave a blank between
one digit and another and wait for a second dialling
tone, etc. (see the explanation provided in step 8).
cap05.p65 25
PROGRAMMING
E N T E R
E N T E R
L A N D R E S . p . A .
E N T E R
0 1 2 5 2 3 0 0 2 5
13/04/00, 22.17
N A M E A
N A M E .
T E L . N O .
+
25