Copying A Configuration To Several Frequency Converters - Danfoss VLT DriveMotor FCP 106 Design Manual

Product Overview
4. Plug the memory module into the MMP.
5. Connect the MMP to a PC to transfer the data
2 2
from the memory module.
Parameter list
Firmware
Motor database
.
.
.
Illustration 2.11 Data Transfer from MMP to PC
6. Insert an empty memory module into the MMP.
7. Select which data to copy from the PC to the
memory module.
Parameter list
Firmware
Motor database
.
.
.
Illustration 2.12 Data Transfer from PC to Memory Module
8. Repeat steps 6 and 7 for each memory module
needed with that particular configuration.
9. Place the memory modules in the frequency
converters.
16
®
VLT DriveMotor FCP 106/FCM 106
Copy
Copy motor
database
Danfoss A/S © 06/2016 All rights reserved.
2.2.3 Copying a Configuration to Several
Frequency Converters
It is possible to transfer the configuration of 1 VLT
®
DriveMotor FCP 106 or VLT DriveMotor FCM 106 to
several others. It only requires a frequency converter that
already has the wanted configuration.
1. Remove the lid from the frequency converter
with the configuration to be copied.
2. Unplug the memory module.
3. Remove the lid from the frequency converter to
which the configuration must be copied.
4. Plug in the memory module.
5. When copying is complete, plug in an empty
memory module in the frequency converter.
6. Place and tighten the lid.
7. Power cycle the frequency converter.
8. Repeat steps 3–7 for each frequency converter
that is to receive the configuration.
9. Place the memory module in the original
frequency converter.
10. Place and tighten the lid.
®
MG03M202