Items You Will Need - Keysight Technologies M9393A Startup Manual

Items You Will Need

To complete the startup process and begin using the instrument, you will need the
following items:
14
Pozidriv P1 or slotted screwdriver to secure the modules into the chassis.
Adjustable torque wrench (at minimum, accommodate an 8 Lb-In [0.904 Nm]
torque on SMA connectors).
If your configuration contains an embedded controller, such as the M9036A
or M9037A:
Monitor with M9036A - Use the DVI-to-VGA adaptor (an accessory to
the M9036A) if necessary
Monitor with M9037A - Use the Display Port to VGA adaptor (an
accessory to the M9037A) if necessary
USB compatible keyboard
USB compatible mouse
A USB flash drive. Download the installer files to a computer, transfer the
installer files to a USB flash drive, and install the software from the USB flash
drive.
A high-quality SMA (male) to SMA (male) cable at least 10 inches (25.4 cm)
long. This cable is used in
signal generator other than the Keysight M9381A PXIe Vector Signal
Generator the cable end at the signal generator RF Output may be different.
Keysight M9393A PXIe Performance Vector Signal Analyzer
Step 6: Make a Measurement . If you are using a