Step 5: Verify Operation Of The Keysight M9393A Pxie Vector Signal Analyzer - Keysight Technologies M9393A Startup Manual

Step 5: Verify Operation of the Keysight M9393A PXIe Vector Signal
Analyzer
In this step you will verify correct operation of the Keysight M9393A PXIe
Performance Vector Signal Analyzer. Before running a Self Test assure that all
required software is installed, the chassis is powered on, and all cabling is correct.
See
The first step in this process is to conduct a Self Test of the >M9393A.
1. Open the M9393A SFP by selecting Start > All Programs > Keysight> M9393 >
M9393 SFP
2. Upon opening the SFP, you are presented with the "Connect to Instrument"
dialog. Use
M9393A and press
3. Check the front panel Status LEDs. See
4. Conduct a Self Test (
Keysight M9393A PXIe Performance Vector Signal Analyzer
Cable the Instruments for proper cabling.
.
Control/Select to select all of the modules that are components of the
Connect
If not all modules and their slot locations are visible in the SFP "Connect to
Instrument" dialog, close the SFP and see
page. After running Keysight Connection Expert, you may restart the SFP.
Utilities > Self Test... > Run Self Test
. For example:
Status LED States
Communications on the following
.
).
45