Troubleshooting Guide - NuWave Nutri-Pot 6Q Owner's Manual & Complete Recipe Book

TROUBLESHOOTING GUIDE

PROBLEM POSSIBLE CAUSE
Silicone Gasket
Difficulty
may not be placed
closing lid.
correctly. Floater
Valve may be blocking
the push rod.
Difficulty Pot may be still
opening lid. under pressure.
Gas leakage Some ingredients
from cooker lid. may get stuck to
the Silicone Gasket.
Silicone gasket may
be broken.
Gas leakage Some ingredients may
from the stick to the Floater
Floater Valve. Valve's sealing circle.
The Floater Valve's
sealing circle may
be broken.
There may not be
Floater Valve
enough ingredients/
does not
raise up. water to generate
enough pressure.
Gas leakage from
lid or Pressure
Release Valve.
The lid is not properly
Pressure not
locked in place.
building up
If the unit needs to be replaced or returned to the manufacturer,
please contact our Customer Service Department at:
1-877-689-2838 • help@nuwavenow.com
RESOLUTION
Place the Silicone Gasket correctly.
Push the Floater Valve to the
correct position.
Check to see if Floater Valve
or Pressure Indicator is still up,
indicaitng there is still pressure
inside. If Floater Valve or Pressure
Indicator is still up, turn Pressure
Release Switch to "OPEN" and
allow all remaining hot steam
to be released.
Clean the Silicone Gasket.Make
sure that the lid is closed as per
instructions on page 14.
Clean the Anti-Clog Filter.The
Floater Valve's sealing circle may
need to be replaced.
Ingredients or water need to be at
minimum level. Unit may need to be
sent to the manufacturer.
Take the lid off and retry. Hold lid,
lower it and turn clockwise to lock.
(Refer to instructions on Pg.14.)
LED panel will light up and display
that Sure Lock™ Safety Feature is
activated. Pressure will start building
up after that.
Owner's Manual
29