Troubleshooting - NuWave PIC TITANIUM Owner's Manual

Hide thumbs Also See for PIC TITANIUM:

Table of Contents

Error

Message

An E1 reading typically means that your NuWave PIC Titanium does

not detect cookware on its surface. This can occur for one of two

reasons.

1. The induction coils contained within the NuWave PIC Titanium will

only work when they are in direct contact with a piece of cookware. To

maintain your appliance's effectiveness, always ensure that it rests on

a flat surface and that contact is consistent with your cookware.

2. An E1 message may also occur if your chosen cookware is not

induction-ready.

The unit is malfunctioning. Contact customer service.

The unit's voltage is too low. Minimum = 85 volts

The unit's voltage is too high. Maximum = 144 volts

The unit is malfunctioning. Contact customer service.

Overheating, or air ventilation is obstructed. If internal temperature

exceeds 230

produced. Press "Pause/Clear" twice. Wait for the unit to cool.

Overheating, if unit exceeds a temperature 20

the appliance will turn off. Contact customer service.

The unit is malfunctioning. Contact customer service.

In programming mode, when the total entered time reaches the

FULL

appliance's limit of 99:60, no additional stages can be inputted.

• When any of the above error messages display on the LED, the unit will "beep" at

least once.

• The fan will run up to a maximum of 60 seconds after pressing the "Pause/Clear

button once. Continue cooking by pressing the "Start" button within 45 minutes.

• The unit will turn off after 45 minutes if no buttons (such as "Start") are pressed.

When the unit shuts off, it will clear all previous cooking history.

• After pressing the "Pause/Clear" button twice or cooking has stopped, the fan will run up

to a maximum of 60 seconds until the unit cools. At that point the NuWave PIC Titanium will

turn off.

After removing

cookware

Initial

< 10 seconds

11- 70 seconds

After 70 seconds

14 •

NuWave

PIC