Troubleshooting Guide - NuWave Nutri-Pot 6Q Owner's Manual & Complete Recipe Book

TROUBLESHOOTING GUIDE

PROBLEM
Difficulty closing lid.
Difficulty opening lid.
Gas leakage from cooker lid. Some ingredients may
Gas leakage from the
Floater Valve.
Floater Valve does not
raise up.
Pressure not building up
If the unit needs to be replaced or returned to the manufacturer, please contact our
Customer Service Department at: 1-877-689-2838 • help@nuwavenow.com
Contact Costumer Service if any of these errors occur
Code
Broken circuit
Error
of sensor
Please immediately cut off circuit and send unit to our Customer
Service Department in case of other problems.
POSSIBLE CAUSE
Silicone Gasket may not
be placed correctly. Floater
Valve may be blocking the
push rod.
The Floater Valve may not
be falling down properly.
Pot may be still under
pressure.
get stuck to the Silicone
Gasket. Silicone gasket
may be broken.
Some ingredients may
stick to the Floater Valve's
sealing circle. The Floater
Valve's sealing circle may
be broken.
There may not be enough
ingredients/water to
generate enough pressure.
Gas leakage from lid or
Pressure Release Valve.
The lid is not properly
locked in place.
E1 E2
Short circuit
of sensor
WARNING
help@nuwavenow.com
RESOLUTION
Place the Silicone Gasket
correctly. Push the Floater
Valve to the correct position.
Push the Floater Valve
Correctly.
Clean the Silicone Gasket.
Make sure that the lid is
closed as per instructions
on page 16.
Clean the Anti-Clog Filter.
The Floater Valve's sealing
circle may need to be
replaced.
Ingredients or water need
to be at minimum level.
Unit may need to be sent
to the manufacturer.
Take the lid off and retry.
Hold lid, lower it and turn
clockwise to lock. (Refer
to instructions on Pg.15.)
LED panel will light up and
display that Sure Lock™
Safety Feature is activated.
Pressure will start building
up after that.
E3
Signal switch
Over heat
Troubleshooting Guide Owner's Manual
E4
broken
29 29