Mechanical installation
The following diagrams and descriptions explain the conditions and procedures involved in
the mechanical installation of the AOP30 operator panel.
Figure 3-1
Dimension drawing of the AOP30 operator panel
Installing the operator panel (cabinet door thickness: 2 mm)
1. Cut out a 141.5 mm x 197.5 mm section in the cabinet door.
2. Fit the AOP30 operator panel in this cutout section from the outside.
3. Apply pressure to the four corners until the snap-in lugs lock into position.
Advanced Operator Panel 30 (AOP30)
Operating Instructions, 11/2017, A5E00331451A
3
15