1. Cut out a 141.5 mm x 197.5 mm section in the cabinet door.
2. Fit the AOP30 operator panel in this cutout section from the outside.
3. Hook the tensioning elements into the openings provided.
4. Tighten the screws by hand to secure the tensioning elements.
NOTICE
Device damage caused by screws being tightened excessively
The excessive tightening of the screws used to fix the tension jack can cause damage to
the operator panel housing!
• Tighten the screws used to fix the tension jack only hand-tight.
Advanced Operator Panel 30 (AOP30)
Operating Instructions, 11/2017, A5E00331451A
Mechanical installation
17