Siemens SINAMICS G130 Operating Instructions Manual page 37

Time base (factory setting: 2 minutes/screen)
The rate of the signal acquisition in minutes per screen is set. The value can be changed in
integer multiples of 2. If an odd value is entered, the value will be rounded up. After changing
the time basis the recording is started again.
Background recording (factory setting: No)
● YES: Values are still recorded, even if the display screen is exited. When the screen is
entered again, the recorded prehistory is displayed.
● NO: The recording is stopped when the curve recorder is exited.
Y scale mode (factory setting: Auto), specifies the representation of the trend
● Auto: Scaling is done automatically (making the best possible use of the display height).
● Manual: Scaling is done manually by entering the range limits MIN/MAX. If, in this mode,
values that are outside the defined window occur, the limit is automatically adapted for
the display so that actual measured values can always be recorded.
Setting the date/time (for date stamping of error messages)
In this menu, you set the date and time.
You can also set whether and/or how the AOP and drive unit are to be synchronized.
Synchronization of the AOP with the drive enables error messages to be date- and time-
stamped.
Note
Display format for the time
The drive unit displays the time in parameter r3102 in the UTC format (days/milliseconds
since 1970-01-01).
Under "Additional settings", settings for synchronization can be made:
Synchronization (factory setting: None)
● None
The times for the AOP and drive unit are not synchronized.
● AOP -> Drive
– If you activate this option, the AOP and drive unit are synchronized immediately
– The current AOP time is transferred to the drive unit every time the AOP is started.
– Depending on the set synchronization interval, the current AOP time is transferred to
Advanced Operator Panel 30 (AOP30)
Operating Instructions, 11/2017, A5E00331451A
whereby the current AOP time is transferred to the drive unit.
the drive unit.
Control via the operator panel
5.5 Menu commissioning / service
35