Siemens SINAMICS G130 Operating Instructions Manual page 38

Control via the operator panel
5.5 Menu commissioning / service
Note
Flashing "S"
If the AOP detects a difference between RAM and ROM during synchronization to the
drive unit, this is indicated by a flashing "S" at the top right in the display or, if operator
input and/or parameter assignment has been disabled, by a flashing key symbol.
● Drive -> AOP
– If you activate this option, the AOP and drive unit are synchronized immediately
– The current drive unit time is transferred to the AOP every time the AOP is started.
– Depending on the set synchronization interval, the current drive unit time is transferred
Note
Time-of-day master
The time in the drive must be set by a clock master (e.g. SIMATIC).
Synchronization interval
The interval for time synchronization is set from 1 hour (factory setting) to 99 hours.
For the interval, the time in the AOP from the time of the last change of the interval is
decisive.
Daylight saving (factory setting: No)
● No
The time does not automatically change over to daylight-saving time.
● Yes
Selection is only possible if synchronization is set to "None" or "AOP -> Drive".
The time is then automatically set to summer or winter time.
After the changeover - for synchronization "AOP -> Drive" - synchronization is
immediately carried out, irrespective of the synchronization interval set.
Changes to the synchronization must be saved with "Save".
Date format
In this menu, the date format can be set:
● DD.MM.YYYY: European date format
● MM/DD/YYYY: North American date format
36
whereby the current drive unit time is transferred to the AOP.
to the AOP.
Advanced Operator Panel 30 (AOP30)
Operating Instructions, 11/2017, A5E00331451A