Table of Contents
Advertisement
Installation
Manual Install—Wired Connection
The computer must have an Ethernet adapter installed. You need two Ethernet cables —
one to connect the RSG2500 to the modem and one to connect the computer to the
RSG2500.
1
If you are currently running broadband to a single computer, unplug the Ethernet cable
connecting your modem to your PC and plug it into the WAN port on the RSG2500. If
you are not running broadband to a single computer, connect an Ethernet cable to the
WAN port on the RSG2500.
2
Connect the other end of the same Ethernet cable to your cable or DSL modem.
You may need to restart your modem after making this connection.
3
Connect a second Ethernet cable to the Ethernet port on the back of your PC.
4
Connect the other end of this cable to one of the LAN ports on your RSG2500.
5
To connect more devices, repeat steps 3 and 4.
RSG2500
Wired connection
Section 2
2-3
Advertisement
Table of Contents
