Installing The Gateway; Connecting To Your Computer; Figure 4 - Svg7782 Connection Diagram - Motorola SURFboard SVG7782 User Manual

Installing the Gateway

3
This product is for indoor use only. Do not route the Ethernet cable
outside of the building. Exposure of the cables to lightning could
create a safety hazard and damage the product.

Connecting to Your Computer

Before installing the gateway:
•
Check with your service provider to ensure high-speed Internet service is available in your area. A
high-speed Internet connection provided by an Internet service provider is needed to set up a
wireless network.
•
Choose a central location in your home where your computer and gateway are preferably near
existing cable and electrical wall outlets.
•
Make sure your computer is powered OFF.
Note: The following procedure steps you through the wired Ethernet connection process to make sure
the gateway is properly connected and your network access is working.
1. Check that a coaxial cable is connected to a cable wall outlet or RF splitter.
2. Connect the other end of the coaxial cable to the Cable connector on the gateway.
Hand-tighten the connectors to avoid damaging them.
3. Connect the Ethernet cable to any open Ethernet port on the gateway.
SVG7782 Wireless Voice Cable Modem Gateway • User Guide
591429-001-a
For Placement Only
Graphic will be available
for next review.
Figure 4 – SVG7782 Connection Diagram
This document is uncontrolled pending incorporation in a Motorola CMS
Installing the Gateway
B
5