Electrical Connection; Establishing Your First Connection To The Hh1620; Easy Install Process; Manual Install - Wired Connection - Motorola HH1620 User Manual

Electrical Connection

Your router does not have an On/Off power switch and therefore will only be powered on by
plugging in the power adapter.
1.
Connect the power adapter to the router's Power port, found on the back of the router.
2.
Plug the power adapter into a grounded and surge-protected power outlet. The Power
LED on the front panel lights green when connected properly.

Establishing Your First Connection to the HH1620

Once the HH1620 is placed, you can now establish your first PC connection to the HH1620.
There are three ways to choose from to accomplish this:
If your first connection will be a wired connection (i.e., an Ethernet cable will connect the
PC and the HH1620), you can follow the step-by-step easy install process with the
included HH1620 Installation Wizard CD-ROM. (recommended)
If your first connection will be a wired connection, but you do not wish to use the
HH1620 Installation Wizard CD-ROM, you can manually install this first wired
connection.
If your first connection will be a wireless connection, you can manually install this first
wireless connection.

Easy Install Process

Run the Installation Wizard program from the supplied CD-ROM to quickly set up your
network. Once your network is up and running, for advanced configuration, see Section 3:
Configuration.
The Installation Wizard will automatically run once you place the CD-ROM in your PC's CD-
ROM drive. It will confirm that the antenna and electrical connections have been made, and
then lead you step-by-step through setting up your HH1620 in a typical configuration as a
wired/wireless router.
Manual Install – Wired Connection
If you are manually connecting your PC with an Ethernet cable to the router, your PC must be
installed first with an Ethernet adapter. You need two Ethernet cables for this procedure, one
to connect the router to the modem and one to connect a PC to the router.
Figure
1.
If you are currently running broadband to a single computer: Unplug the Ethernet cable
that runs between your modem and PC from the back of your PC and plug it into the
HH1620 Wireless VoIP Gateway
User's Guide
16
Troubleshooting