Table of Contents
Advertisement
G
the wiper system. Two codes are set based on the condition of the on/off relay control wire open,
E
shorted to ground or shorted to battery. The third code will set if the wiper motor park switch fails
N
to open and close.
E
R
3.17
Diagnostic Trouble Codes Information
A
L
3.17.1
Airbag Trouble Codes
I
The airbag control module may report any of the following diagnostic trouble codes.
N
For the following codes, replace the airbag control module (ACM) even if set intermittently:
F
O
ACM ACCELEROMETER
R
ACM FIRING STORED ENERGY CODE
M
ACM INTERNAL DIAGNOSTIC CODE #1
A
T
For these codes, refer to the appropriate diagnostic procedure:
I
Cluster Message Mismatch
O
Driver Squib Circuit Open
N
Driver Squib Circuit Shorted
Driver Squib Circuit Shorted to Battery
Driver Squib Circuit Shorted to Ground
Loss of Ignition Run Only
Loss of Ignition Run/Start
No Cluster Message
No Cluster IFR Communication
No PCI Communication
Passenger Squib Circuit Open
Passenger Squib Circuit Shorted
Passenger Squib Circuit Shorted to Battery
Passenger Squib Circuit Shorted to Ground
Power Stage Not Tested
Warning Lamp open/shorted
3.17.2
Audio Trouble Codes
Radio Error
CD Error
Cass Error
Shorted Front Channel
Shorted Rear Channel
Shorted Left Channel
Shorted Right Channel
3.17.3
Body Control Module Diagnostic Trouble Codes
ABS Bus Communication Failure
A/C Control A/C Switch Failure
A/C Control Blend Door Input Open Or Shorted to ground
A/C Control Blend Door Input Shorted to Battery
A/C Control EBL Switch Failure
A/C Control Mode Door Input Open Or Shorted to Battery
A/C Control Mode Door Input Shorted to Ground
ATC Messages Not Received
ATC Switch Failure
Airbag Bus Communication Failure
Ambient Temperature Sensor Failure
ACM INTERNAL DIAGNOSTIC CODE #2
ACM OUTPUT DRIVER
16
Advertisement
Table of Contents
Troubleshooting
