Chrysler 300M 1999 Manual page 617

TEST 12A
CONTINUED - REPAIRING INOPERATIVE DECKLID RELEASE
TEST 12A
CONTINUED FROM
THE PREVIOUS
PAGE.
CONNECT A JUMPER
WIRE BETWEEN THE
FUSED B(+) AND
THE...
LEAVE JUMPER
CONNECTED.
DISCONNECT THE BCM
C1 HARNESS CONN.
SEE GENERAL INFO 4.0
DISCONNECT THE
JUMPER WIRE AND
THE TEST LIGHT.
REMOVE THE BODY
CONTROL MODULE
FROM THE JUNCTION
BLOCK.
*Perform Verification TEST VER-2A.
WITH THE TEST
LIGHT STILL
CONNECTED FROM THE
PREVIOUS PAGE.
DECKLID RELEASE
SWITCH OUTPUT
CIRCUITS.
FIG. 1
USING A VOLTMETER,
MEASURE THE DECKLID
RELEASE SWITCH
OUTPUT CIRCUIT.
FIG. 2
CONNECT A JUMPER
WIRE BETWEEN THE
DECKLID RELEASE
CONTROL CKT AND
GROUND. FIG. 3
CONNECT A TEST LIGHT
BETWEEN B (+) AND
THE DECKLID RELEASE
CONTROL CIRCUIT.
FIG. 4
**Check connectors - Clean / repair as necessary.
607
DID THE TEST LIGHT YES
ILLUMINATE?
NO
IS THE VOLTAGE NO
ABOVE 10.0 VOLTS?
YES
IS THE TEST LIGHT NO
ILLUMINATED?
YES
REPLACE THE
DECKLID RELEASE
SWITCH.*
REPAIR THE OPEN
DECKLID RELEASE
SWITCH OUTPUT
CIRCUIT.*
REPAIR THE OPEN
DECKLID RELEASE
CONTROL CIRCUIT.
IF OK, REPLACE THE
JUNCTION BLOCK.*
REPLACE THE BODY
CONTROL MODULE.*
P
O
W
E
R
D
O
O
R
L
O
C
K
S
Y
S
T
E
M