Chrysler 300M 1999 Manual page 229

TEST 5A
REPAIRING CHIME INOPERATIVE WITH KEY IN IGNITION AND DRIVER DOOR OPEN
Perform TEST 1A Before Proceeding
START TEST 5A.
TURN THE IGNITION
KEY OFF
AND
OPEN THE DRIVER
DOOR.
WITH THE DRB,
READ THE DRIVER
DOOR AJAR SWITCH
STATUS.
ENSURE THE KEY IS
IN THE IGNITION
SWITCH.
DISCONNECT THE
IGNITION SWITCH
HARNESS
CONNECTOR.**
CONNECT A JUMPER
WIRE BETWEEN THE
KEY-IN IGNITION
SWITCH SENSE CIRCUIT
AND GROUND. FIG. 1
GAIN ACCESS TO THE
BODY CONTROL
MODULE C2 HARNESS
CONNECTOR.**
FIG. 2
*Perform Verification TEST VER-2A.
NOTE: FOR LOCATION
OF ALL COMPONENTS.
SEE GENERAL INFO 4.0
DID THE CHIME
SWITCH: CLOSED"?
WITH THE DRB,
READ THE KEY-IN
IGNITION SWITCH "KEY-IN IGNITION
STATUS.
CONNECT A JUMPER
WIRE BETWEEN THE
KEY-IN IGNITION SW "KEY-IN IGNITION
SENSE CKT AND THE
GROUND CKT. FIG. 1
"KEY-IN IGNITION
CONNECT A JUMPER
WIRE BETWEEN THE
KEY-IN IGNITION "KEY-IN IGNITION
SWITCH SENSE CIRCUIT
AND GROUND. FIG. 3
**Check connectors - Clean / repair as necessary.
219
YES THE CHIME IS
SOUND? OPERATIONAL WITH
NO PROBLEM FOUND.*
NO
DOES THE DRB
DISPLAY NO PERFORM
"DRDOOR AJAR "DOOR AJAR"
TEST 1A.
YES
DOES THE DRB
DISPLAY YES REPLACE THE BODY
CONTROL MODULE.*
SW: CLOSED"?
NO
DOES THE DRB
DISPLAY YES REPLACE THE
IGNITION SWITCH.*
SW: CLOSED"?
NO
DOES THE DRB
DISPLAY YES REPAIR THE OPEN
GROUND CIRCUIT.*
SW: CLOSED"?
NO
DOES THE DRB
DISPLAY NO REPLACE THE BODY
CONTROL MODULE.*
SW: CLOSED"?
YES
REPAIR THE OPEN
KEY-IN IGNITION
SWITCH SENSE
CIRCUIT.*
C
H
I
M
E
S
Y
S
T
E
M