Repairing Chime Sounds With Driver Door Open - Chrysler 300M 1999 Manual

TEST 9A

REPAIRING CHIME SOUNDS WITH DRIVER DOOR OPEN

Perform TEST 1A Before Proceeding
START TEST 9A.
REMOVE THE
IGNITION KEY AND
OPEN THE DRIVER
DOOR.
WITH THE DRB, READ
THE KEY IN
IGNITION SWITCH
STATUS.
DISCONNECT THE
IGNITION SWITCH
HARNESS
CONNECTOR.**
DISCONNECT THE
BODY CONTROL
MODULE C2 HARNESS
CONNECTOR.**
*Perform Verification TEST VER-2A.
NOTE: FOR LOCATION
OF ALL COMPONENTS.
SEE GENERAL INFO 4.0
WITH THE DRB, READ
THE KEY IN
IGNITION SWITCH
STATUS.
WITH AN OHMMETER,
MEASURE BETWEEN
GROUND AND THE KEY
IN IGNITION SWITCH
SENSE CKT. FIG. 1
**Check connectors - Clean / repair as necessary.
227
NOTE: TURN OFF ALL
INTERIOR AND
EXTERIOR LIGHTS.
DID THE CHIME NO
SOUND?
YES
DOES THE DRB
DISPLAY NO
"KEY IN IGNITION
SWITCH: CLOSED"?
YES
DOES THE DRB
DISPLAY NO
"KEY IN IGNITION
SWITCH: CLOSED"?
YES
IS THE RESISTANCE NO
BELOW 5.0 OHMS?
YES
THE CHIME IS
OPERATIONAL WITH
NO TROUBLE FOUND.
REPLACE THE BODY
CONTROL MODULE.*
REPLACE THE
IGNITION SWITCH.*
REPLACE THE BODY
CONTROL MODULE.*
REPAIR THE KEY IN
IGNITION SWITCH
SENSE CIRCUIT FOR
A SHORT TO
GROUND.*
C
H
I
M
E
S
Y
S
T
E
M