Reference Edit - ABB ACS850 Manual

Reference Edit

In the Reference Edit option, you can:
• accurately control the local reference value,
• start, stop, change the direction and switch between local and remote control.
Editing is allowed only in the LOC state, the option always edits the local reference
value.
How to edit reference value
Step Action
1. If the panel is in the remote control mode (REM shown on
the status line), switch to local control (LOC shown on the
status line) by pressing
possible in remote control mode. (See page
information on switching between the local and remote
control modes.)
The display shows a message about that if you try to
enter REF EDIT in the remote control mode.
2. Otherwise, go to the Main menu by pressing
are in the Output mode.
Otherwise press
Main menu.
3. Go to the Reference Edit option by selecting REF EDIT
on the menu with keys
ENTER
.
4. Select the correct sign with keys
NEXT
press . Select the correct numbers with keys
and , and after each number is selected, press
NEXT
.
5. After the last number is selected, press
Output mode by pressing
value is shown in the status line.
LOC . Reference editing is not
REM
EXIT
repeatedly until you get to the
and
and
SAVE
EXIT
. The selected reference
The ACS850 control panel 49
Display
REM
Reference editing
enabled only in
22 for more
local control mode
MENU
if you
LOC
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
LOC
, and pressing
+
CANCEL
, and
LOC
-
CANCEL
. Go to the
LOC
DIR
MESSAGE
00:00
MAIN MENU
ENTER
00:00
REF EDIT
0000.00
rpm
00:00 NEXT
REF EDIT
1250.00
00:00 SAVE
-1250.00rpm
49. 10
Hz
0. 50
A
10. 7
%
MENU
00:00
1
rpm