Honeywell EXCEL 5000 User Manual page 91

EXCEL CARE CONTROL ICONS
Datapoints Button
User Address
ID___Tariff
IA___Energy_Intv
STARTUP (see Note)
ID___Sync_failed
ID___Peak_load
ID___Shutdown
ID___Off_Prio_1
ID___Off_Prio_2
Type abbreviations:
DI: Digital input
VA: Virtual (pseudo) analog
Click the Datapoints button to display the datapoints dialog box for XFM 35. Click
on Set for each of the XFM pointnames. CARE automatically creates user
addresses with the same names. Later sections describe how to use these points
depending on operation desired. The table following the dialog box summarizes user
address types and functions.
The Counter_Zi, last pointname is handled differently from the other pointnames.
After hightlighting Counter_Zi, click on the totalizer point in the schematic.
Type Input/
Output
VD Input 0: Use power limit P13
1: Use power limit P14
VA Output User address to indicate the current energy consumption (kWh)
within the Measurement Interval [window] (change engineering units
to kWh)
VD Input 0: Normal operation (application is not running)
1: Start-up operation (application is running)
VD Output 0: Signal to initiate an alarm when the synchronization impulse
is missing
1: Signal is not active
(Set Active State of this point to 1)
VD Output 1: Signal to all XFM 36-1/S/R to stop switching on the loads
0: Signal is not active
VD Output 1: Signal to all XFM 36-1/S/R to shed the loads immediately
0: Signal is not active
Input:
VD Input/
Output 0: There is no load to switch off in priority group 1
1: There is at least one load to switch off in priority group 1
Output:
0: Reset of the loads-available-to-turn-off detection for the
priority group 1
Input:
VD Input/
Output 0: There is no load to switch off in priority group 2
1: There is at least one load to switch off in priority group 2
Output:
0: Reset of the loads-available-to-turn-off detection for the
priority group 2
93
ALPHABETIC REFERENCE
Comment
EN2B-0184 GE51 R0518 (Europe)
74-5577–33 (US)