Installation; Preparing For The Installation; Positioning The Machine - Wexiodisk WD-PRM6 Installation And User Manual

Installation instructions

3.4 Installation

3.4.1 Preparing for the installation

Check that there is sufficient room for the machine at the installation location.
•
•

3.4.2 Positioning the machine

Check the following points before the machine is placed in position:
•
•
•
•
Place the machine in position and check that it, and any accessories, are horizon-
tally level. Adjust the height with the legs.
Check with a spirit level that is standing level. Place the spirit level on the join be-
tween the machine tank and the upper part. Once the machine has been filled
with water, do another check to make sure the machine is standing level.
A=Distance between the machines, with or without a cabinet (option)
WD-PRM6 & WD-PRM7
Check that correct connections are available for water, electricity, drainage
and possibly steam at the installation location. See TECHNICAL SPECIFI-
CATIONS.
The level pipe in the connected dishwasher must be removed and replaced
by a bottom filter.
Check that the fuse for the machine at the site is off, blocked and that out-
going electrical circuits from the machine are non-live.
Remove the protective plastic on the sides which are to be stood against a
wall.
The distance between the wall and machine should be at least 20 mm.
If the machine is to be corner-loaded, it must be positioned with the control
panel furthest away from the wall.
WD-6x WD-6x
WD-7x WD-7x
WD-8x WD-8x
WD-12x WD-12x
WD-PRM6 WD-PRM6
WD-PRM7 WD-PRM7
140
WD-6x
WD-7x
WD-8x
WD-12x
WD-PRM6
WD-PRM7
A
10
WD-6x
WD-7x
WD-8x
WD-12x
WD-PRM6 WD-PRM6
WD-PRM7 WD-PRM7
300
WD-6x
WD-7x
WD-8x
WD-12x
WD-PRM6
WD-PRM7
300
20
Rev. 5.0 (201902)
WD-6x
WD-7x
WD-8x
WD-12x
A
303082_R2