Enabling Ppp Mode - Sierra Wireless AirLink RV50 Product Manual

Click Reboot to restart the module. Alternately, reset the module by pressing Reset on the front
of the module or by removing power from the module.
Click Logout to terminate communications with the module.
WARNING:
Unless you Apply the commands, the changes made will not be saved in the module. For
most commands, you must reboot the module for the newly written values to take effect.
The module is now set up in serial server mode. Alternatively, to enable PPP mode, see
PPP mode (p. 23).

7.5 Enabling PPP mode

The first step in enabling PPP mode is using the template file to configure the RV50 as described
in ACEManager and template files
Launch the Device Configuration Utility
On the Datalogger tab, change the data logger PakBus Address and optional PakBus/TCP Pass-
word to match the values entered in the
On the Com Ports Settings tab, Select the COMPort where the module is connected; this is gen-
erally RS-232 or CS I/O. When connecting to the CS I/O port, the default address is SDC8. When
connecting via RS-232, change the Baud Rate to 115200 Fixed.
(p. 20)
. All tabs are within the Deployment category.
Set up Konect PakBus Router
RV50 Sierra Wireless AirLink® 4G LTE Cellular Modem
Enabling
(p. 6) step.
23