Konect Pakbus Router Setup; Get Started - Sierra Wireless AirLink RV50 Product Manual

To install the micro-SIM card:
1. Remove the SIM card cover.
2. Note the location of the notched corner for correct alignment. The gold contact points of
the SIM face down when inserting the SIM card as shown in
the card into the slot until it stops and locks into place. To eject the SIM card, press it in
slightly and release.
3. Replace the SIM card cover.

4.3 Konect PakBus Router setup

For better security, we recommend using Konect PakBus® Router with a private dynamic IP
address. This method allows only incoming PakBus communication. No other incoming com-
munication is supported. However, all forms of outbound communication from the data logger
are supported, including but not limited to PakBus, email, and ftp. Complete the steps in the fol-
lowing two sections.

4.3.1 Get started

Open a web browser and go to www.konectgds.com.
First-time users need to create a free account. After you submit your information, you will receive
two emails up to five minutes apart. One email will contain a Passport ID and the other your Pass-
word. If emails are not received, check your email junk folder.
FIGURE 4-1. SIM card installation
RV50 Sierra Wireless AirLink® 4G LTE Cellular Modem
FIGURE 4-1 (p. 4). Gently slide
4