Installation; Base Station Requirements; Data Logger Site Equipment - Sierra Wireless AirLink RV50 Product Manual

Industry Certifications
Safety: IECEE Certification Bodies Scheme (CB Scheme), UL60950
l
Vehicle Usage: E-Mark (UN ECE Regulation 10.04), ISO7637-2, SAE J1455 (Shock & Vibra-
l
tion)
Hazardous Environments: Class 1 Div 2
l
Environmental: RoHS, REACH, WEEE
l

7. Installation

7.1 Base station requirements

A computer running Campbell Scientific LoggerNet software with access to the Internet is
needed.

7.2 Data logger site equipment

RV50 module with power cable (included with module)
l
Data logger — CR1000X series, CR300 series, CR6 series, CR1000, CR3000, CR800 series, and
l
CR200(X) series
Module Interface, see
l
Environmental Enclosure — ENC10/12, ENC12/14, or ENC16/18
l
If connecting to CS I/O port:
SC105 Interface — connects the module to any data logger with a CS I/O port. It must
be configured using Device Configuration Utility. Settings should be:
CS I/O Mode: Modem Enable
l
CS I/O ME Baud Rate: 9600
l
RS-232 Mode: Modem (default)
l
Baud Rate:
l
l
l
8 data bits, 1 stop bit, no parity
l
If connecting to RS-232 port:
Null Modem Cable (9 pin, male-to-male) — connects the module to the CR1000X series,
Module communications connections
115.2K for CR1000X series, CR300 series, CR6 series, CR1000, CR3000, CR800
series, and CR200(X) series data loggers
9600 for CR10X, CR10X-PB, CR510, CR510-PB, CR23X, and CR23XPB data log-
gers
RV50 Sierra Wireless AirLink® 4G LTE Cellular Modem
(p. 18)
14