Table of Contents
Advertisement
7.3
Configuration of the reading properties
7.3.1
Reading the same code multiple times
To prevent the same code from being repeatedly read and output in presentation mode, a
reread delay delay time can be configured that must elapse before the same code can be
read again.
By default, four preset times are available for selection for reread delay:
• Short = 500ms
• Medium = 750ms
• Long = 1000ms
• Extra long = 2000ms
By reading in one of the following configuration codes, the reread delay time is set to the
corresponding value.
Figure 7.12: Configuration codes for setting the reread delay time
If these four preset times are not sufficient, you can define an application-specific time for
reread delay in the range from 0 ... 30,000ms.
Leuze electronic
Short = 500ms
Long = 1000ms
Technical description LSIS 22x
Configuration using configuration codes
Medium = 750ms
Extra long = 2000ms
39
Advertisement
Table of Contents
