Configuration Using Configuration Codes; Configuration Of Interface; Rs 232 Parameter - Lsis 222 M5M-R1; Figure 7.1: Configuration Code Rs 232 Standard Parameters - Leuze electronic LSIS 222 Technical Description

Configuration using configuration codes

7 Configuration using configuration codes
The LSIS 22x is configured with the aid of configuration codes. After reading in these
codes, the device parameters are set in the device and permanently stored.
Notice!
Using Aztec configuration codes, many parameters can be set simultaneously; using
1-dimensional configuration codes, on the other hand, it is generally only possible to set
individual parameters.
7.1

Configuration of interface

7.1.1

RS 232 parameter - LSIS 222 M5M-R1

By reading in the following configuration code, the RS 232 interface is set to the following
standard parameters (factory settings):
• Baud rate
• Data format
• Framing
• No read character
• Manual trigger mode
Figure 7.1:
Notice!
The LSIS 222 M5M-R1 and the connected host must be set to the same interface parame-
ters.
30
Configuration code RS 232 standard parameters
Technical description LSIS 22x
9600bit/s
8 data bits, no parity, 1 stop bit
<STX>DATA<CR><LF>
'?'
start command: <SYN>T<CR>
stop command: <SYN>U<CR>
Leuze electronic