Before Upgrading The P330 Stack Processor; Before Upgrading The Mgp Processor And Media Modules - Avaya G700 Installation Manual

Before upgrading the P330 stack processor

Use the ping and set ip route commands for the P330 stack processor:
1. At the P330-1(super)# prompt, type ping <tftp_server_address>, where
<tftp_server_ip_address> is the IP address (on the customer's LAN) of the TFTP
server that contains the firmware image files.
If you get a reply, the connection is OK. If you do not get a reply with the ping command,
the TFTP server address may be on a different subnet from the address of the P330 stack
processor.
If so, you can set the default gateway with the set ip route command.
2. At the P330-1(super)# prompt, type set ip route 0.0.0.0
<default_gateway_address>, where
<default_gateway_address> is the IP address (on the customer's LAN) of the router
that connects the G700's subnetwork with other networks.

Before upgrading the MGP processor and media modules

The ping and set ip route commands are a little different for the MGP processor:
1. At the MG-001-1(configure)# prompt, type
ping mgp <tftp_server_address>
2. At the MG-001-1(configure)# prompt, type
set ip route 0.0.0.0 <subnet mask> <default_gateway_address>, where
<subnet_mask> is the mask for this subnet (for example, 255.255.255.0).
Install New Firmware on the P330 Stack Processor (P330 Device
Manager)
Follow this procedure to upgrade the firmware on the P330 stack processor.
1. Telnet to the P330 stack processor and login.
2. At the P330-1(super)# prompt, type
copy tftp
<tftp_server_address>
<image-file> is the software image file with format and vintage number similar to
viisa4_0_17.exe.
<ew_file> is an embedded web application file with format similar to
p330Tweb.4.0.4.exe.
SW_image <image-file>
<Module#>, where:
Install New Firmware on the G700 Media Gateway
EW_Archive
555-245-758 Issue 4 February 2006
<ew_file>
13