Connection For The Download Step; Connection To The S8300 For The Install Step - Avaya G700 Installation Manual

Connection for the Download Step

To download the firmware image files, connect to the Internet and point your web browser to
http://support.avaya.com. Save the files to your computer's hard drive.

Connection to the S8300 for the Install Step

The Install step can be done by connecting the technician's laptop in one of the following ways:
LAN Connection
●
Direct Connect to the S8300
●
Direct Connection to the G700 Serial Port
●
LAN Connection
To install the downloaded firmware image files, connect your laptop or PC to the customer's
LAN then telnet to the P330 stack processor. If your laptop or PC is not registered on the
customer's LAN, you will need to work with the LAN administrator to assign an IP address to
your computer.
After connecting to the customer LAN, connect to the P330 stack processor:
1. Telnet to the P330 stack processor —
Go to Start > Run and enter telnet <IP address>, where <IP address> is the IP
address of the P330 stack processor.
2. Log in as root at the Welcome to Avaya P330 screen.
Direct Connect to the S8300
If the G700 has an S8300 installed (either as the active controller or in LSP mode) you can
connect a laptop to the Services port on the S8300.
The laptop must have the following TCP/IP configuration:
- IP address: 192.11.13.5
- Subnet mask: 255.255.255.252
- No DNS or WINS servers specified
To set up a direct connection to the S8300:
1. Connect a crossover cable from the network interface card (NIC) on your laptop to the
services port (RJ-45 jack) in the middle of the S8300.
2. Telnet to 192.11.13.6 on the S8300.
3. Log in as craft or cust.
4. You can now telnet to the P330 stack processor.
555-245-758 Issue 4 February 2006
Overview
5