Avaya G700 Installation Manual page 16

Job Aid: Firmware Download Procedures for the G700 Media Gateway
Note:
If you are using a TFTP server other than an S8300 Media Server, you must
Note:
enter the full path name for <image-file>; for example, c:\tftpboot\
mgp_22_16_0.bin.
<tftp_server_ip_address> is the IP address of the TFTP server.
For example,
copy tftp
The screen will show the progress.
6. After the prompt returns, type set mgp bootimage <bank> to identify the bank (A or B)
that contains the new mgp image file.
This is the bank to which you copied the image file in 5. When the system is reset, it will use
the image file in this bank.
For example,
set mgp bootimage b
7. At the MG-001-1(configure)# prompt, type reset mgp
8. Select Yes to continue.
The G700 Media Gateway processor will reset and you will loose your telnet connection.
The LEDs on the G700 Media Gateway and the Media Modules will flash. These elements
will each conduct a series of self-tests. When the LEDs on the Media Modules are
extinguished and the active status LEDs on the G700 Media Gateway are on, the processor
reset is complete.
9. Telnet back to the MGP and verify that the download was successful. At the
MG-001-1(configure)# prompt, type show mgp bootimage
Check the version number under IMAGE VERSION for the bank listed under ACTIVE NOW.
FLASH MEMORY
Bank A
Bank B
ACTIVE NOW
Bank B(22.16.0)
10. If there are additional G700s in the stack, install the new firmware in each of the mgp
processors. (See
16 Firmware Download Procedures for the G700 Media Gateway
mgp-image b c:\tftpboot\mgp_22_16_0.bin
IMAGE VERSION
22.16.0
22.16.0
ACTIVE AFTER REBOOT
Bank B(22.16.0)
Stack Configurations on page 18).
195.123.49.54