lancer BLENDPOINT Operation Manual page 17

TROUBLE
Little or no flavor in drinks.
Too much flavor in drinks.
Ice chunks in drinks.
Water won't dispense.
Product bag is leaking.
Lid light in on.
Low ice indicator.
CAUSE
• Product bags are empty.
• Product hoses are kinked.
• More than one pump is turning at one time.
• A pump is turning that was not requested.
• A single pump is turning as long as the ice
is dispensing.
• Blend time in the program for that product
is off.
• Cavitation is caused when the liquid and
ice mixture in the blender jar is too thick
and an air pocket is created around the
spinning blender blade.
• Water supply is OFF or blocked.
• Water supply line is kinked.
• Product bag is torn or ripped.
• Ice hopper lid is malfunctioning
• Ice level in ice hopper not high enough
REMEDY
• Ensure product bags are not empty and if
so then replenish accordingly.
• Unkink product hoses
(Contact the manufacturer if pumps do not turn)
• Check the programming for any of these
conditions and if any are present then
contact the manufacturer.
• See Section 4 above to reprogram the
blend time correctly.
• Be sure to put in enough products to pro-
duce a good flavor then adjust the water to
ice ratio until the blender does not cavitate
when you make your drink.
• Ensure water supply is ON if not then
switch on. If water line is blocked then
clear obstruction.
• Unkink water supply line.
(If neither problems exist contact manufacturer)
• Replace the bag.
• Replace ice hopper lid.
(If replacing the lid does not clear the light
contact your manufacturer for further help)
• Add ice to the ice hopper to a level above
the photo-electric eyes which are located
inside the ice hopper on each side.
• (If the light does not go off then contact
your manufacturer for further help)
17