lancer BLENDPOINT Operation Manual page 15

8. Using a soft cloth or sponge, clean the product line
connections on all of the product bags with sanitizing
solution, then press Next.
CLEAN PRODUCT LINES
Once hoses are disconnected from product bag, use spray bottle
filled with sanitizer, to clean connections on product bag.
Next
Home Back
NOTE
The unit will begin flushing warm water through the
product lines. Each pump will run for one whole cycle
(approximately 25 seconds) to ensure lines are
completely flushed of any remaining product.
9. Empty and replace jar in Blend Station, if needed.
10. Place ends of product hoses into a bucket of cleaning
solution then press Next.
CLEAN PRODUCT LINES
Prepare bucket of cleaner, place end of hoses in bucket,
press next when ready.
Next
Home Back
NOTE
The unit will begin to fill the product lines with
cleaning solution. Each pump will run for one whole
cycle (approximately 25 seconds) to ensure lines are
completely flushed of any remaining product.
11. Let cleaning solution sit in lines for ten (10) minutes before
continuing.
12. Empty and replace jar in Blend Station, if needed.
2/10
Main Menu
4/10
Main Menu
13. Place ends of product hoses into a bucket of sanitizing
solution then press Next.
CLEAN PRODUCT LINES
Prepare bucket of sanitizer, place end of hoses in bucket,
press next when ready.
Next
Home Back
NOTE
The unit will begin to fill the product lines with
sanitizing solution. Each pump will run for one whole
cycle (approximately 25 seconds) to ensure lines are
completely filled with sanitizing solution.
14. Let sanitizing solution sit in lines for ten (10) minutes before
continuing.
15. Empty and replace jar in Blend Station, if needed.
16. Replace product bags and trays.
17. Reconnect product hoses to their corresponding product
bags then press Next.
CLEAN PRODUCT LINES
Remove hoses from bucket, then reconnect hoses to product bags.
Press next to prime hoses with product.
Next
Home Back
NOTE
The unit will begin to fill the product lines with the
original product. Each pump will run for one whole
cycle (approximately 25 seconds) to ensure sanitizing
solution is completely flushed from the system.
! CAUTION
Following sanitization, rinse with end-use product
until there is no aftertaste. Do not use a fresh water
rinse. This is a nsf requirement. Residual sanitizing
solution left in the system creates a health hazard.
18. Taste each product to verify there is no off-taste.
19. If off-taste is found, flush the product system again by using
the Manual Controls option, (See Manual Controls Section,
page 10).
20. Press and hold each product number for one whole cycle
(approximately 25 seconds) to ensure off-taste does not
occur.
6/10
Main Menu
8/10
Main Menu
15