lancer BLENDPOINT Operation Manual page 14

Blend Station:
1. Remove blender jar and splash guard. Empty jar if needed.
2. Using cleaning solution, wipe down all surfaces of the blend
station, including the blend station door. Excess water will
drain through drain opening located at the back of the unit.
3. Use clear, hot water to rinse blend station. Avoid getting
excess water on the motor.
4. Using sanitizing solution, spray solution on all surfaces of
the blend station including the nozzle ports located on the
upper portion where splash guard is located and wipe with
a clean rag.
5. Using the brush provided, clean and sanitize ice chute
located on the upper surface of the blend station. Slide
brush all the way through the ice chute to the other side
making sure to cover all interior surfaces.
6. Clean and sanitize splash guard.
7. Replace splash guard, blender jar.
Ice Hopper:
1. Place empty jar in the blend station and turn OFF the
power.
2. Manually remove and discard as much ice as possible from
the ice hopper.
3. Turn ON the power.
4. In the Manual Controls section found on the Main Menu,
press and hold the Ice button to discharge all remaining ice
in the hopper (See Manual Controls Section, page 10).
5. Empty jar and replace in the blend station.
6. Turn OFF power
7. Fill another jar with cleaning solution and apply to ice
hopper.
8. Make sure to apply cleaning solution to all interior surfaces
of the ice hopper, both of the augers, the crusher plate, and
the three (3) plastic bushings. Empty jar in Blend Station
and replace.
9. Wipe down all surfaces of the ice hopper with a clean,
damp rag.
10. Fill another jar with warm water and run over all surfaces
of the ice hopper until there is no cleaning solution present,
watch the water level in the jar to ensure it does not
overflow. Empty jar as needed.
11. Fill another jar with sanitizing solution and apply to all
interior surfaces of the ice hopper including both of the
augers, the crusher plate, and the three (3) plastic
bushings.
12. Wipe down all surfaces of the ice hopper with a clean,
damp rag soaked with sanitizing solution.
NOTE
For further Ice Hopper cleaning instructions see
Cleaning section found on the Main Menu
14
Product Lines:
1. Disconnect all product lines from their corresponding
product bags.
2. Remove all product bags and trays.
3. From the "Home Screen" press the Main Menu button.
4. Press Cleaning.
MENU
Replace
Inventory
Product
Manual
Fault History
Controls
Home Back
5. Press Clean Product Lines.
CLEANING
Clean Clean Ice
Product Lines Hopper
Home Back
6. Place an empty jar into the Blend Station.
7. Place ends of product hoses into a bucket of warm water
then press Start.
CLEAN PRODUCT LINES
Place cleaning jar on blender, disconnect hoses from
bags and place hoses in a bucket of warm water.
Start
Home Back
Cleaning Calibrate
Machine
About
Lockout
Main Menu
1/10
Main Menu