Ip Interface Commands; Basic Ip Configuration; Ip Address - SMC Networks SMC8612XL3 F 1.0.1.3 Management Manual

IP Interface Commands

There are no IP addresses assigned to this router by default. You must
manually configure a new address to manage the router over your network
or to connect the router to existing IP subnets. You may also need to a
establish a default gateway between this device and management stations
or other devices that exist on another network segment (if routing is not
enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to
connect subnetworks to the enterprise network.
Command Group
Basic IP
Configuration
Address Resolution
Protocol (ARP)

Basic IP Configuration

Command

ip address

ip default-gateway
show ip interface
show ip redirects
ping
ip address
This command sets the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.
-116
Function
Configures the IP address for interfaces and the gateway
router
Configures static, dynamic and proxy ARP service
Function
Sets the IP address for the current interface
Defines the default gateway through which this router
can reach other subnetworks
Displays the IP settings for this device
Displays the default gateway configured for this device PE
Sends ICMP echo request packets to another node on
the network
Pag
e
3-11
6
3-12
2
Mod Page
e
IC 3-116
GC 3-118
PE 3-119
3-120
NE, 3-120
PE