Igmp Commands (Layer 3); Ip Igmp - SMC Networks SMC8612XL3 F 1.0.1.3 Management Manual
Smc networks gigabit ethernet switch management guide
Hide thumbs
Also See for SMC8612XL3 F 1.0.1.3:
- Technical specifications (2 pages) ,
- Installation manual (72 pages) ,
- Brochure (4 pages)
Table of Contents
Advertisement
IGMP Commands (Layer 3)
Command
ip igmp
ip igmp robustval
ip igmp query-interval
ip igmp
max-resp-interval
ip igmp
last-memb-query-interv
al
ip igmp version
show ip igmp interface Displays the IGMP configuration for specified
clear ip igmp group
show ip igmp groups
ip igmp
Use this command to enable IGMP on a VLAN interface. Use the no
form of this command to disable IGMP on the specified interface.
Syntax
ip igmp
no ip igmp
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Function
Enables IGMP for the specified interface
Configures the expected packet loss
Configures frequency for sending host query
messages
Configures the maximum host response time
Configures frequency for sending group-specific
host query messages
Configures IGMP version used on this interface IC
interfaces
Deletes entries from the IGMP cache
Displays detailed information for IGMP groups NE,
M
F
ULTICAST
ILTERING
C
OMMANDS
Mode Page
IC
3-107
IC
3-108
IC
3-109
IC
3-110
IC
3-111
3-112
NE,
3-113
PE
PE
3-113
3-114
PE
-107
- Quick Links:
- Connecting to the Switch
- Resetting the System
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SMC8612XL3 F 1.0.1.3 and is the answer not in the manual?
Questions and answers
RPU you light is off. what does it mean? it doesnt even blink when powering the switch. How to I reset the switch?
If the RPU (Redundant Power Unit) light is off on the SMC Networks SMC8612XL3 switch, it means that no redundant power supply is connected.
To reset the switch, you can typically do the following:
1. Use the command line interface (CLI) to issue a reset command if available.
2. Power cycle the switch by turning it off and then back on.
3. If needed, press the reset button on the switch if it has one.
Ensure you save any configurations before resetting to avoid losing settings.
This answer is automatically generated