Snmp Commands; Snmp-Server Community - SMC Networks SMC8612XL3 F 1.0.1.3 Management Manual

Command Mode
Privileged Executive
Example
Console#show access-group
Interface ethernet 1/2
IP standard access-list david
MAC access-list jerry
Console#

SNMP Commands

Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
Command
snmp-server
community
snmp-server contact Sets the system contact string
snmp-server location Sets the system location string
snmp-server host
snmp-server enable
traps
snmp ip filter
show snmp

snmp-server community

This command defines the community access string for the Simple
Network Management Protocol. Use the no form to remove the specified
community string.
Function
Sets up the community access string to permit
access to SNMP commands
Specifies the recipient of an SNMP notification
operation
Enables the device to send SNMP traps (i.e.,
SNMP notifications)
Sets IP addresses of clients allowed management
access to the switch via SNMP
Displays the status of SNMP communications
SNMP C
OMMANDS
Mode Page
GC 3-147
GC 3-148
GC 3-149
GC 3-150
GC 3-151
GC 3-152
NE, 3-154
PE
4-147