Ip Host; Default Setting - SMC Networks SMC8624/48T Management Manual

C L
OMMAND INE

ip host

This command creates a static entry in the DNS table that maps a host
name to an IP address. Use the no form to remove an entry.
Syntax
[no] ip host name address1 [address2 ... address8]
• name - Name of the host. (Range: 1-64 characters)
• address1 - Corresponding IP address.
• address2 ... address8 - Additional corresponding IP addresses.

Default Setting

No static entries
Command Mode
Global Configuration
Command Usage
Servers or other network devices may support one or more
connections via multiple IP addresses. If more than one IP address is
associated with a host name using this command, a DNS client can try
each address in succession, until it establishes a connection with the
target device.
Example
This example maps two address to a host name.
Console(config)#ip host rd5 192.168.1.55 10.1.0.55
Console(config)#end
Console#show hosts
Hostname
rd5
Inet address
10.1.0.55 192.168.1.55
Alias
Console#
4-158
I
NTERFACE