Table of Contents
Advertisement
C
ONFIGURING THE
•
Capabilities – Specifies the capabilities to be advertised for a port
during auto-negotiation. (To access this item on the web, see
"Configuring Interface Connections" on page 3-48.) The following
capabilities are supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
- 1000full - Supports 1000 Mbps full-duplex operation
- Sym - Transmits and receives pause frames for flow control
- FC - Supports flow control
•
Broadcast storm – Shows if broadcast storm control is enabled or
disabled.
•
Broadcast storm limit – Shows the broadcast storm threshold.
(500 - 262143 packets per second)
•
Flow control – Shows if flow control is enabled or disabled.
•
LACP – Shows if LACP is enabled or disabled.
•
Port Security – Shows if port security is enabled or disabled.
•
Max MAC count – Shows the maximum number of MAC address
that can be learned by a port. (0 - 20 addresses)
•
Port security action – Shows the response to take when a security
violation is detected. (shutdown, trap, trap-and-shutdown)
•
Combo forced mode – Shows the forced/preferred port type to use
for combination ports 21-24. (copper forced, copper preferred auto,
SFP forced, SFP preferred auto)
Current status:
•
Link Status – Indicates if the link is up or down.
•
Operation speed-duplex – Shows the current speed and duplex
mode.
•
Flow control type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
3-82
S
WITCH
Advertisement
Table of Contents
