Dns Commands - SMC Networks SMC8624/48T Management Manual

DNS Commands

These commands are used to configure Domain Naming System (DNS)
services. You can manually configure entries in the DNS domain name to
IP address mapping table, configure default domain names, or specify one
or more name servers to use for domain name to address translation.
Note that domain name services will not be enabled until at least one name
server is specified with the ip name-server command and domain lookup
is enabled with the ip domain-lookup command
Command
ip host
clear host
ip domain-name
ip domain-list
ip name-server
ip domain-lookup
show hosts
show dns
show dns cache
clear dns cache
Table 4-31. DNS Commands
Function
Creates a static host name-to-address
mapping
Deletes entries from the host
name-to-address table
Defines a default domain name for
incomplete host names
Defines a list of default domain names for
incomplete host names
Specifies the address of one or more name
servers to use for host name-to-address
translation
Enables DNS-based host name-to-address
translation
Displays the static host name-to-address
mapping table
Displays the configuration for DNS services PE
Displays entries in the DNS cache
Clears all entries from the DNS cache
DNS C
OMMANDS
Mode Page
GC 4-158
PE 4-159
GC 4-159
GC 4-160
GC 4-162
GC 4-163
PE 4-164
4-165
PE 4-165
PE 4-166
4-157