SMC Networks SMC8624/48T Management Manual page 397

Command Usage
• If you do not enter an snmp host command, no notifications are sent.
In order to configure the switch to send SNMP notifications, you must
enter at least one snmp host command. In order to enable multiple
hosts, you must issue a separate snmp host command for each host.
• The snmp-server host command is used in conjunction with the
snmp enable traps command. Use the snmp enable traps
command to specify which SNMP notifications are sent globally. For
a host to receive notifications, at least one snmp enable traps
command and the snmp host command for that host must be
enabled.
• Some notification types cannot be controlled with the snmp enable
traps command. For example, some notification types are always
enabled.
• The switch can send SNMP version 1 or version 2c notifications to a
host IP address, depending on the SNMP version that the
management station supports. If the snmp-server host command does
not specify the SNMP version, the default is to send SNMP version 1
notifications.
Example
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands
snmp enable traps (4-154)
SNMP C
OMMANDS
4-153