Cisco ASA Series Cli Configuration Manual page 1674

Group Policies
•
•
Default Group Policy
The ASA supplies a default group policy. You can modify this default group policy, but you cannot delete
it. A default group policy, named DfltGrpPolicy, always exists on the ASA, but this default group policy
does not take effect unless you configure the ASA to use it. When you configure other group policies,
any attribute that you do not explicitly specify takes its value from the default group policy. To view the
default group policy, enter the following command:
hostname(config)# show running-config all group-policy DfltGrpPolicy
hostname(config)#
To configure the default group policy, enter the following command:
hostname(config)# group-policy DfltGrpPolicy internal
hostname(config)#
Note
The default group policy is always internal. Despite the fact that the command syntax is
hostname(config)# group-policy DfltGrpPolicy {internal | external}, you cannot change its type to
external.
To change any of the attributes of the default group policy, use the group-policy attributes command
to enter attributes mode, then specify the commands to change whatever attributes that you want to
modify:
hostname(config)# group-policy DfltGrpPolicy attributes
Note
The attributes mode applies only to internal group policies.
The default group policy, DfltGrpPolicy, that the ASA provides is as follows:
hostname# show run all group-policy DfltGrpPolicy
group-policy DfltGrpPolicy internal
group-policy DfltGrpPolicy attributes
banner none
wins-server none
dns-server value 10.10.10.1.1
dhcp-network-scope none
vpn-access-hours none
vpn-simultaneous-logins 3
vpn-idle-timeout 30
vpn-idle-timeout alert-interval 1
vpn-session-timeout none
vpn-session-timeout alert-interval 1
vpn-filter none
ipv6-vpn-filter none
vpn-tunnel-protocol ikev1 ikev2 l2tp-ipsec ssl-client ssl-clientless
password-storage disable
ip-comp disable
re-xauth disable
group-lock none
pfs disable
Cisco ASA Series CLI Configuration Guide
1-40
Client configuration settings
Connection settings
Chapter 1 Configuring Connection Profiles, Group Policies, and Users