Cisco ASA Series Cli Configuration Manual page 1775

Chapter 1 Configuring Network Admission Control
Command
Step 1
global
Step 2
eou clientless username username
Example:
hostname(config)# eou clientless username sherlock
hostname(config)# eou clientless password 221B-baker
hostname(config)#
Step 3
eou clientless password password
Step 4
(Optional)
no eou clientless username
Example:
hostname(config)# no eou clientless username
hostname(config)#
Step 5
(Optional)
no eou clientless password
Example:
hostname(config)# no eou clientless password
hostname(config)#
Changing NAC Framework Session Attributes
The ASA provides default settings for the attributes that specify communications between the ASA and
the remote host. These attributes specify the port no. to communicate with posture agents on remote
hosts and the expiration counters that impose limits on the communications with the posture agents.
These attributes, the default settings, and the commands you can enter to change them are as follows:
Changing Global NAC Framework Settings
Purpose
Switches to global configuration mode.
Changes the username used for clientless
authentication.
username must match the username configured on
the Access Control Server to support clientless
hosts. Enter 1 to 64 ASCII characters, excluding
leading and trailing spaces, pound signs (#),
question marks (?), quotation marks ("), asterisks
(*), and angle brackets (< and >).
Changes the username and password for clientless
authentication to sherlock and 221B-baker
respectively. You can specify only the username,
only the password, or both.
Changes the password used for clientless
authentication.
password must match the password configured on
the Access Control Server to support clientless
hosts. Enter 4 – 32 ASCII characters.
Changes the username to its default value.
Changes the password to its default value.
Cisco ASA Series CLI Configuration Guide
1-15