Cable Mount & Truss Assembly - HARVEST H1364XT Assembly Manual

Step 7
(Cable Mount & Truss Assembly)
st
In Step 7 the lower cable mount brackets will be installed. On the 1 tube bolt cable mount brackets (31972) to
the left & right side of the hopper arm bracket as shown. These will be fastened using (2) 5/8" x 1-1/2" flange
bolts & nuts. Insert a 3/4" eyebolt into each hole of the cable mount bracket and attach each with 1 flat washer,
ext. tooth lock washer, & hex nut as shown in fig. 7.1. If assembling and H1374 or H1384XT attach the upper
st
cable mount brackets to the 1 tube as shown in fig. 7.2. Attach the brackets and eyebolts with the same
process as the lower cable winch mount brackets.
Fig. 7.1 Fig. 7.2
Step 8
nd
Next the cable truss uprights assembled on the 2 tube. Start by placing the 2 upright truss brackets (31971) &
2 of the side cable supports (13221) on the tube and fastening with a total of (12) 1/2" x 1-1/2" flange bolts &
flange nuts. Leave these a little loose for ease of assembling the cross member. Next, assemble the cross
member (13223) using a total of (4) 3/8" x 1" flange bolts & flange nuts as shown. Next, assemble the 2 "X"
braces as shown using (6) 3/8" x 1" flange bolts and nuts. Tighten all fasteners in this step. After all fasteners
are tigtened, place (2) 1/4" cable clamps on the side cable supports. Thread nuts on by hand but do not tighten.
Fig. 8.1
H13XT Assembly Manual Page 7 of 33