HARVEST H1364XT Assembly Manual page 28

Step 40
Using a lifting strap, lift the scissor hinge part of the carriage up to the auger tube. Lift carriage up within
approximately 1/4" of the auger tubes. Be sure to keep the discharge end the auger supported at this time. Lift
both carriage arms up and attach to the lower carriage mount bracket using a 1-1/4" x 19-3/8" pin. Secure the
pin through the bracket with (2) 3/8" x 3" roll pins. Next move to the carriage arm spacer plate & tighten the
(4) 3/8" x 1" flange bolts & flange nuts.
Fig. 40.1
Step 41
Route the hydraulic hose attached to the tube up and around the upper scissors and back through the carriage
mount bracket on the tube. (Fig. 41.1) Mount the hydraulic hose to the inner part of the upper scissors using
(2) 1/2" hose "P" clamps & 1/4" flange nuts as shown in fig. 41.2.
Fig. 41.1
H13XT Assembly Manual
Fig. 40.2
Fig. 41.2
Page 28 of 33