HARVEST H1364XT Assembly Manual page 10

Step 12
Locate the #60 chain, #60 half link, & #60 connector link. Attach the half link to the chain on one end & place
the chain around the sprockets as shown in fig. 12.1. Secure chain with connector link. When connector link is
installed & the loop has been completed, push the idler sprocket in the chain to achieve good tension. When
proper tension is achieved tighten the idler sprocket. Now grease top & bottom bearings with multi-lith grease.
Fig. 12.1
Step 13
Next, insert a 3/8" x 1-1/2" square key into the bottom shaft. Slide PTO shaft onto lower drive shaft. Align
holes in PTO shaft with hole in drive shaft. Using a punch will help in this application. Secure using a 3/8" x
3-1/2" hex bolt & top lock nut. Tighten set screw on PTO shaft.
Fig. 13.1
H13XT Assembly Manual Page 10 of 33