Truss Cable Assembly - HARVEST H1364XT Assembly Manual

Step 21

(Truss Cable Assembly)

Take 1 long 1/2" cable & attach it to the upper eyebolt located in the middle of the first tube. Secure using (2)
1/2" cable clamps Pull cable to first truss and through a 1/2" cable clamp on the top of the truss. When the
cable is through the cable clamp, continue pulling the cable to the quicklink located on the discharge end of the
last tube. Secure using (2) 3/8" cable clamps as shown if figure 21.3. Repeat on opposite side of the auger.
Always have saddles of the cable clamps on the "live" end of the cable.
Fig. 21.1 Fig. 21.2
Fig. 21.3
H13XT Assembly Manual Page 15 of 33