HARVEST H1364XT Assembly Manual page 22

Step 30
Locate the right scissor arm. Attach the scissor arm to the axle using a 1-1/4" x 6-3/4" pin. Secure the pin with
(2) 3/8" x 3" roll pins. (Fig. 30.1) Attach the other end of the scissor are to the cylinder cross tube as shown in
fig. 31.2. Fasten the scissor arm to the cross tube using (5) 3/4" x 2" hex bolts & flange nuts. Repeat this step
for the left scissor arm.
Step 31
Locate the transport support tube assembly. Move the bracket between the two scissor arms. Make sure that
the upright rest arms are leaning away from the axle. Attach each side using (4) 5/8" x 1-1/2" flange bolts &
nuts. Do not tighten.
H13XT Assembly Manual
Fig. 30.1
Fig. 31.1
Fig. 30.2
Fig. 31.2
Page 22 of 33