HARVEST H1364XT Assembly Manual page 27

Step 38
Next, lift one side of the axle off the ground. Locate the 2 hub assemblies & 2 wheels. Attach the hub to the
axle using (6) 1/2" x 1-1/2" hex flange bolts & flange nuts. Tighten these bolts. Mount the wheel on to the hub
and secure using (6) 1/2" lug nuts. Tighten lug nuts to 90 ft/lbs of torque evenly using a "star" pattern. Repeat
this step to assemble the hub & wheel on the other side.
Fig. 38.1
Step 39
(Carriage To Tube Assembly)
nd
Lift the tubes using a lifting strap. Lift auger so that the carriage mount bracket on the bottom of the 2 tube is
slipped between the upper scissor arms. Align the holes in the scissor arm & the mount bracket using a punch.
When holes are align, mount tubes to the carriage using a 1-1/4" x 23" pin. Secure the pin through the upper
scissors with (2) 3/8" x 3" roll pins. Release lifting strap and move to the front of the carriage.
Fig. 39.1 Fig. 39.2
H13XT Assembly Manual Page 27 of 33