Step 18
Next the hopper winch will be mounted. On the right side of the infeed housing attache the winch mount
bracket (10131B) to the infeed housing using (4) 3/8" x 1" hex flange bolts & flange nuts. Next, mount the
winch retain bracket (10251) to the winch and secure with (3) 3/8" x 1" carriage bolts & flange nuts as shown in
fig. 18.1. Tighten bolts by hand only for now. Slide the winch handle onto winch with spring & nut. Tighten
nut to secure handle. Place winch on top of the mount bracket and secure with the 1/2" pin & hairpin. Angle
st
the winch so it is centered with the top bracket (hopper arm bracket) on the 1
tube. Tighten the (3) 3/8" x 1"
carriage bolts. Next, mount the other winch mount bracket on the left side of the infeed housing. Attach as
shown in fig. 18.2 with (4) 3/8" x 1" hex flange bolts & flange nuts.
Fig. 18.1
Fig. 18.2
Step 19
(Transport Arm Assembly)
st
After the left hand side winch mount bracket is secured, assemble the hopper transport arm to the 1
tube. This
will be done by attaching the arm mount brackets (10676) using (6) 3/8" x 1" hex flange bolts & nuts. Mount
arm on brackets using (1) clevis pin and 1/8" x 1-1/2" cotter pin as shown in figure 20.2.
Fig. 19.1
Fig. 19.2
H13XT Assembly Manual
Page 13 of 33