Step 28
Attach the carriage arms to the axle as shown in fig. 28.1. Fasten the carriage arms to the axle using
(4) 5/8" x 1-1/2" flange bolts and nuts. Do not tighten these bolts at this time.
Step 29
Locate the cylinder cross tube assembly. Place on the ground between the 2 carriage arms. Place
approximately two thirds of the way down the carriage arms from the axle as shown in fig. 29.1. Be sure to
place cylinder cross tube with the holes for the cylinder in the direction of the axle.
H13XT Assembly Manual
Fig. 28.1
Fig. 29.1
Page 21 of 33